Solutions

Continuous decarburization and annealing unit for cold-rolled silicon steel (CNGO)

Category: Solution

The cold-rolled non-oriented silicon steel (CNGO) is degreased, decarburized and annealed, and recrystallized annealed under a protective atmosphere to reduce the carbon content of the strip to the specified range, to grow the grains, improve the magnetic properties, eliminate stress, and apply an insulating layer.

Details

  For cold-rolled non-oriented silicon steel (CNGO) Surface degreasing is performed, and decarburization annealing and recrystallization annealing are performed in a protective atmosphere. The carbon content of the strip is reduced to the specified range, the grain size is increased, the magnetic level is improved, stress is eliminated, and an insulating layer is applied.
 
   Main Technical Parameters
  Raw materials: Cold-rolled hard-state steel coils of non-oriented electrical steel (Si≤2.0%) W470-W1300
  Strip carbon content: C≤50ppm
  Strip thickness: 0.35-0.65mm
  Strip width: 900-1250mm
  Product: Cold-rolled electrical steel coil
  Representative specifications: 50W470-50W600 50W800-50W1300
  Quality standard: GB/T2521-1996
  Carbon content: C≤27ppm
  Unit speed: Inlet 0-200mpm, process section 0-135mpm, outlet section 0-200mpm
  Annual output: 200,000tpy
  Energy saving method: Comprehensive utilization of waste gas heat recovery, SUNNY patent
  Continuous decarburization annealing furnace: Non-oxidizing heating (NOF) + full radiation tube heating (RTF), vertical and horizontal
  Fuel type: Natural gas, liquefied petroleum gas
  Decarburization method: Continuous decarburization with protective gas
  Insulating layer coating: Using roller coater + coating drying and curing
  Welding equipment: Narrow lap seam welder
  Degreasing method: Chemical degreasing + electrolytic degreasing + three-stage water rinsing, vertical or horizontal
  Electrical control system: SIEMENS or ABB AC frequency conversion automatic control system
  Industrial automation: SIEMENS or ABB intelligent automatic control system
 
   Main production process flow
 
 Main Technical Parameters
 
  Uncoiling → Welding → Degreasing (alkaline spraying → alkaline scrubbing → electrolytic degreasing → hot water cleaning → drying) → Decarburization annealing → Cooling → Coating insulation layer → Sintering → Cooling → Surface inspection → Slitting → Coiling

Related Solutions